Engine specific production specifications for 360 401 engines.
Amc 401 rod length.
Information about amc engines and their specifications.
All molnar rods are finished in the united states at the molnar technologies shop in michigan.
Like the 390 factory recommended overbore is only 0 020 in 0 51 mm but commonly bored by 0 030 in 0 76 mm.
The 70 tall deck amc 390 has a unique piston and rod combo that makes it different from the 68 69 variety.
K1 amc engine rod sets listed below have the correct amc rod beam offset.
The 401 has 2 090 inch rod and 2 248 inch main journals which means you can swap the.
It was last produced in 1979.
The 401 was available in the javelin matador and ambassador car lines and in jeeps from its introduction in 1971 through 1974.
These rod sets come complete with 3 8 arp 2000 rod bolts installation instructions and arp moly lube.
Some folks if anal enough will start slightly off center.
Rod jrnl crankshaft rod journal diameter in inches.
A 401 with a factory 401 head with guide plates done right and with roller rockers sbf or amc will take a pushrod length of 8 140 8 160.
But hope to soon.
Amc 360 rods 390 rods 401 connecting rods and amc stroker rods.
Bore rod big end housing bore diameter in inches.
C c length of rod center to center in inches.
Stock 5 858 rod bearings.
Amc 360 390 401 rods.
View this page as large as possible and under high resolution for best results.
Getting 500 lb ft and more than 480 horses from an amc 401.
I do not have current numbers at this time.
Pin wrist pin size that rod is designed to work with.
Like the 390 the 401 s crankshaft and connecting rods are forged steel.
These rod sets come complete with 8 rods 7 16 arp 2000 rod bolts installation instructions and assembly lube molnar amc engine rod sets listed below have the correct amc rod beam offset.
Getting 500 lb ft and more than 480 horses from an amc 401.
That is 250 off the rocker bosses and the thickness of the guideplate to center the tip of the roller.
